One piece hand hole protecting handle. We manufacture it in two dimensions - for two cardboard thicknesses 5-8mm and 5-10mm. It is a medium size hand hole protector in comparison to its bigger counterpart protector 211.1
The handle is mounted to the side of the box through elliptical cut-out.
It is usually used in pairs - one for each side panel of your box. It protects the hand from the cardboard edge but at the same time it protects the cardboard from tearing (which happens quite often if there is simply a cut-out in the box without our protection).
Most important handle dimensions are shown in the drawing, production tolerances may change these values to some extent - e.g. depending on the material properties. If you want to know the tolerances please contact us.
Dimension | Value | Dimension | Value | Dimension | Value |
---|---|---|---|---|---|
A: | 105mm | F: | 17mm | K: | 14mm |
B: | 86mm | G: | 22mm | L: | 5-8 or 5-10mm |
C: | 48mm | H: | 12mm | ||
D: | 39mm | I: | 2.5mm | ||
E: | 30mm | J: | 12mm |
This handle is made of original Polypropylene material. Our raw material suppliers are carefully chosen and always provide us with the spec sheets of the materials.
The spec sheet contains product dimensions, packaging cut-out dimensions, and all other parameters contained in this webpage- all in a compact PDF format.
Several products that are commonly used with this handle or simliar to it.