Two piece hand hole protecting handle. We manufacture it in three dimensions - for two cardboard thicknesses 5mm or 8mm. It is a big size hand hole protector in comparison to its smaller counterpart protector 211.0
The handle is mounted to the side of the box through elliptical cut-out.
Every handle consists of two halves, which are joined together in a simple click actio. The protector is usually used in pairs - one for each side panel of the box. It protects the carrier palm and fingers from contact with the cardboard edge and at the same time it protects the cardboard from tearing (by non-uniform pressure exerted by fingers).
Most important handle dimensions are shown in the drawing, production tolerances may change these values to some extent - e.g. depending on the material properties. If you want to know the tolerances please contact us.
|C:||5 or 8mm||H:||141mm|
|E:||8mm for 5mm cardboard|
This handle is made of original Polypropylene material. Our raw material suppliers are carefully chosen and always provide us with the spec sheets of the materials.
The spec sheet contains product dimensions, packaging cut-out dimensions, and all other parameters contained in this webpage- all in a compact PDF format.